How to do a firmware restart

A firmware restart resets the settings of the bike and restarts the electrical system support.
It can be helpful to correct the following problems:

  • Minor faults or deviations in the behaviour of the bike.
  • Problems with the power button.
  • Communication problems between Ampler Bike App and bike.

You can perform this through the button or the app.
Here is how it works through the button:

On Generation 1 models (button on the seat tube)

To restart your firmware:

  1. Hold down the power button for at least 10 seconds (20 seconds if you have a model before 2017) until the LED light turns off along with the bike. Don't let go earlier.
  2. Turn the bike on again from the power button or let it charge a while, if the battery has run out
  3. Check the connection via your app and see if everything works as it should

Watch this video to see how it works, please note that this video reflects the switched-on state. If you have the new firmware, the bike behaves differently in the switched-off state – as mentioned above.

For Generation 2 models (button on the top tube below the display)

  1. Hold the button down for ~8 seconds until the restart icon appears .
  2. Let go of the button.
  3. Your Ampler restarts the firmware.
  4. The bike will turn itself on again by itself. Let it charge for a while if the battery is empty.
  5. Check the connection with the app and see if everything is OK.

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.